S370FIBw.d

S370FIBw.d

Reads integer binary (fixed-point) values, including negative values, in IBM mainframe format

Category: Numeric

Syntax
Syntax Description
Details
Comparisons
Examples
See Also

Syntax

S370FIBw.d

Syntax Description

w

specifies the width of the input field.

Default:	4
Range:	1-8

d

optionally specifies the power of 10 by which to divide the value.

Range:

0-10

Details

The S370FIBw.d informat reads integer binary (fixed-point) values that are stored in IBM mainframe format, including negative values that are represented in two's complement notation. S370FIBw.d reads integer binary values with consistent results if the values are created in the same type of operating environment that you use to run SAS.

Use S370FIBw.d for integer binary data that are created in IBM mainframe format for reading in other operating environments.

Note: Different operating environments store integer binary values in different ways. This concept is called byte ordering. For a detailed discussion about byte ordering, see Byte Ordering on Big Endian and Little Endian Platforms. [cautionend]

Comparisons

If you use SAS on an IBM mainframe, S370FIBw.d and IBw.d are identical.
S370FPIBw.d, S370FIBUw.d, and S370FIBw.d are used to read big endian integers in any operating environment.
To view a table that shows the type of informat to use with big endian and little endian integers, see SAS Informats and Byte Ordering.
To view a table that compares integer binary notation in several programming languages, see Integer Binary Notation and Programming Languages.

Examples

You can use the INPUT statement and specify the S370FIB informat. However, this example uses the informat with the INPUT function, where the binary input value is described by using a hex literal.

x=input('0080'x,s370fib2.);

SAS Statement Results

put x=;

128

See Also

SAS Statement	Results
put x=;	128

Informats:

S370FIBUw.d

S370FPIBw.d

Chapter Contents
Previous
Next
Top of Page