Chapter Contents
Chapter Contents		 Previous
Previous		 Next
Next
User Interface Features

Command Panel

The command panel holds icons representing commonly used netWorks commands. By positioning the cursor over a command icon and then clicking the left mouse button, you can invoke the corresponding netWorks command. The commands are as follows:

                animate.gif (232 bytes)
toggle animation controls
                start.gif (232 bytes)
start simulation routine
                stop.gif (229 bytes)
stop simulation routine
                interupt.gif (226 bytes)
pause simulation routine
                resetp.gif (226 bytes)
reset
                control.gif (232 bytes)
display simulation control panel
                paths.gif (220 bytes)
display paths control panel
                vport.gif (273 bytes)
create viewport
                save.gif (207 bytes)
save current network model
                attrib.gif (254 bytes)
edit models control panel
                alignt.gif (214 bytes)
display alignment control panel
                help.gif (207 bytes)
help

Again, the details for these commands are interspersed in appropriate sections throughout this document.

Chapter Contents
Chapter Contents		 Previous
Previous		 Next
Next		 Top
Top

Copyright © 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.